Brake calipers squeeze the pads against the rotors, and a sticking or seized caliper causes pulling, dragging, and overheating. On a heavy Sprinter that means uneven wear and lost stopping power. We confirm the failed caliper, replace it, fit fresh pads if needed, and bleed the corner for even Riverside stops.
What this service includes
- Confirm the sticking or leaking caliper as the fault
- Replace the caliper and inspect the slides and bracket
- Fit new pads and check the rotor surface
- Bleed the corner and road test for even braking
Signs your Sprinter needs it
- Van pulls to one side when braking
- One wheel runs hot, smells, or drags
- Fluid leaking at a wheel or uneven pad wear
What does brake caliper replacement cost?
Ballpark pricing for brake caliper replacement on a Sprinter runs $400 to $1,500. The final number depends on your model, mileage, and the exact cause, which we confirm with Xentry before any work is authorized. Diagnostic time is credited toward the repair. See the full pricing page.
Frequently asked questions
Can a stuck caliper ruin other parts?
Yes. A dragging caliper overheats and glazes the pads and warps the rotor, and it wastes fuel. Replacing it early on your Sprinter keeps the repair from spreading.
Do calipers get replaced in pairs?
Not always. If one caliper fails and the other tests fine, replacing the single unit is reasonable. We check both so you only pay for what your van actually needs.