Telematics integration installs GPS trackers, data loggers, and connected hardware into your Sprinter fleet so dispatch sees location, mileage, and engine health in real time. We wire each unit cleanly, verify data feeds, and set up vehicles so your Riverside operation manages routes and maintenance from one dashboard.
What this service includes
- Install GPS and telematics hardware to factory wiring standards
- Tie into the OBD port or module for engine and diagnostic data
- Verify live feeds for location, mileage, and fault reporting
- Test each van and confirm the fleet dashboard reads correctly
Signs your Sprinter needs it
- You are rolling out a new telematics platform across the fleet
- You need engine and location data pulled into dispatch
- Existing trackers were wired poorly and drop signal or drain batteries
What does telematics integration cost?
Ballpark pricing for telematics integration on a Sprinter runs $300 to $2,500. The final number depends on your model, mileage, and the exact cause, which we confirm with Xentry before any work is authorized. Diagnostic time is credited toward the repair. See the full pricing page.
Frequently asked questions
Will telematics wiring affect my Sprinter electronics?
Not when it is done right. We tap approved circuits and route clean harnesses so the install does not trip faults or drain the battery on parked Riverside vans.
Can you install trackers I already bought?
Yes. We fit customer supplied telematics units, integrate them with the van, and confirm they report correctly, or we can recommend hardware that suits your fleet.